After I had made the foil lids work on my homemade Kratky containers, the next problem appeared: I could not see inside the container to know where the water level was, because many of the containers were black.

Black containers — impossible to see the water level inside

Black containers — no way to see the water level inside. This was a bigger problem than expected.

At first, I solved it by cutting a small flap into the food bucket lids with a utility knife. Just enough to lift a little "hatch" and add nutrient solution.

Small flap cut into a food bucket lid with a utility knife — the first inspection hatch

The first inspection hatch — a flap cut with a utility knife. Not pretty, but it worked.

📏 The Measuring Stick and Wine Cork

Because I couldn't see inside the container, I made a measuring stick — with a wine cork attached to the end so it would float. I drew marks on the stick: when to add water, how much to add, and what the maximum level was.

Measuring stick in use — checking water level in a dark container — bamboo with numbered marks and a cork float wrapped in tape

In use — lowering the stick to find the water level in a black container — bamboo, tape, a wine cork, numbers 1–10

It was clumsy, but it was the only way. Even so, I still made mistakes. I drowned the roots many times. But each mistake taught me more about what CALYXA® would need.

💡 The Liquid Window — Born by Accident

When I lined the larger containers with newspaper to block light, I accidentally left a small gap. And through that gap, I could see the water level.

Large root system visible through the side gap of the container — the accidental first Liquid Window

The accidental gap in the newspaper — and through it, the water level and the massive root system below

"If I can see the water level from the side, I don't need a measuring stick or a hatch."

I drew a line on the paper to show the maximum level. That was the first version of the Liquid Window.

✨ From Accident to Protected Design

This simple observation led directly to the CALYXA® Liquid Window:

CALYXA® Liquid Window — 3mm light-tight window with Start, Max and Refill markings on the container side

The final Liquid Window — 3 mm wide, light-tight, with Start / Max / Refill markings molded into the container

A 3 mm wide window that lets you see the water level from outside — without letting any light into the root zone. Start, Max and Refill — all visible at a glance.

All these small, handmade solutions — the knife-cut flap, the measuring stick with a wine cork, the accidental newspaper gap — were crucial steps on the way to the final CALYXA® container.

← Light‑Reflective Lid™ | Next: How the Final Lid Shape Was Created →